Your Cart is Empty
Made in the USA
Trusted by DIY & Professionals
Est. 1978
Fast Shipping
Developed by in-house PHD chemists
Have a Question? ASK THE EXPERT
item(s): 44904
POR-15 Matte Clear Coat premium quality water-based 2-part coating seals in any color or patina for a custom low sheen look, that lays out consistently coat after coat, with amazing results! POR-15 Matte Clear Coat is specifically designed to deliver an extreme level of resistance to scuffing and burnishing, and be a leader in high-performance waterborne matte clear coatings. POR-15 Matte Clear Coat is formulated with a low VOC, Waterborne Polyurethane Clear Coat technology that achieves a low sheen through chemistry and is silica-free, so No tiger-striping. This protective clear coat for metal also has excellent weathering properties and can be used on any substrate that can be cleared with a traditional clear coat. UV resistance is comparable to high-performance solvent-based clear coats, and protects your base-coat colors. Matte Clear can be thinned with distilled water if necessary.
Coverage: One gallon mixed covers 340 sq ft with One coat at 1.8 mil thickness.
One gallon should be enough for small-mid size car. One gallon and two quarts for a short bed truck. Two gallons for a multi-cab or extended bed truck.
POR-15 Matte Clear Coat Technical Data Sheet
Stir Matte Clear Coat Parts A and B before mixing.
2.4:1 Mixing ratio: 2.4 parts Matte Clear to 1 Part Hardener ( Thin or reduce with Distilled water only ). Stir well (do not shake)
CONVENTIONAL - Suggested SPRAY GUN SET UP
Apply with a 60% overlap 2 full wet coats.
1. Prepare your base as you would most other substrates.
2. Apply 2 full coats or until desired coverage has been achieved.
3. Allow to flash off properly between coats.
4. Allow 15 minutes before baking for 30 minutes @ 90˚F.
Note: Always spray a test panel to ensure desired gloss level. Variations in application, temperature, and gun set up can affect the final gloss. Keep application speed, gun distance, and tecnique consistent.
SURFACE PREPARATION: For use over all base coats, as well as previously base-coated substrates that are properly prepared. Surface must be clean, free of oil, wax, or grease, and completely dry.
APPLICATION: Stir Matte Clear Coat before mixing. Combine 2.4 parts by volume of Matte Clear Coat Part A with 1 part by volume of Matte Clear Coat Hardener Activator Part B. Stir well, do not shake. Use distilled water to thin if necessary.
Apply with a 60% overlap 2 full wet coats. 1. Prepare your base as you would most other substrates. 2. Apply 2 full coats or until desired coverage has been achieved. 3. Allow to flash off properly between coats. 4. Allow 15 minutes before baking for 30 minutes @ 90˚F
DRY TIME: Dust Free: 55min; Air Dry (Touch) 2 hours; Baking @ 90˚F 30min