Matte Clear Coat
$131.90 -
$494.33
item(s): 44904
POR-15 Matte Clear Coat premium quality water-based 2-part coating seals in any color or patina for a custom low sheen look, that lays out consistently coat after coat, with amazing results! POR-15 Matte Clear Coat is specifically designed to deliver an extreme level of resistance to scuffing and burnishing, and be a leader in high-performance waterborne matte clear coatings. POR-15 Matte Clear Coat is formulated with a low VOC, Waterborne Polyurethane Clear Coat technology that achieves a low sheen through chemistry and is silica-free, so No tiger-striping. This protective clear coat for metal also has excellent weathering properties and can be used on any substrate that can be cleared with a traditional clear coat. UV resistance is comparable to high-performance solvent-based clear coats, and protects your base-coat colors. Our automotive clear coat matte can be thinned with distilled water if necessary.
Coverage: One gallon mixed covers 340 sq ft with One coat at 1.8 mil thickness.
One gallon should be enough for small-mid size car. One gallon and two quarts for a short bed truck. Two gallons for a multi-cab or extended bed truck.
- Low Sheen Protective Clear Coat
- Consistent Sheen
- Waterborne Polyurethane Clearcoat Technology
- Burnish Resistant
- Non-yellowing clear protective coating for metal
- Silica-Free
POR-15 Matte Clear Coat Technical Data Sheet
Dry Time:
- Dust Free: 55 minutes
- Air Dry (Touch) 2 hours
- Baking @ 90˚F. 30 minutes
Product mixing
Stir Matte Clear Coat Parts A and B before mixing.
2.4:1 Mixing ratio: 2.4 parts Matte Clear to 1 Part Hardener ( Thin or reduce with Distilled water only ). Stir well (do not shake)
Application
CONVENTIONAL - Suggested SPRAY GUN SET UP
- 1.2 - 1.4 Fluid tip
- 4 - 8 inch Spray distance
- 20 - 45 psi Air pressure at regulator
- 8 - 11 psi at cap
Apply with a 60% overlap 2 full wet coats.
1. Prepare your base as you would most other substrates.
2. Apply 2 full coats or until desired coverage has been achieved.
3. Allow to flash off properly between coats.
4. Allow 15 minutes before baking for 30 minutes @ 90˚F.
Note: Always spray a test panel to ensure desired gloss level. Variations in application, temperature, and gun set up can affect the final gloss. Keep application speed, gun distance, and tecnique consistent.
SURFACE PREPARATION: For use over all base coats, as well as previously base-coated substrates that are properly prepared. Surface must be clean, free of oil, wax, or grease, and completely dry.
APPLICATION: Stir Matte Clear Coat before mixing. Combine 2.4 parts by volume of Matte Clear Coat Part A with 1 part by volume of Matte Clear Coat Hardener Activator Part B. Stir well, do not shake. Use distilled water to thin if necessary.
Apply with a 60% overlap 2 full wet coats. 1. Prepare your base as you would most other substrates. 2. Apply 2 full coats or until desired coverage has been achieved. 3. Allow to flash off properly between coats. 4. Allow 15 minutes before baking for 30 minutes @ 90˚F
DRY TIME: Dust Free: 55min; Air Dry (Touch) 2 hours; Baking @ 90˚F 30min