Detail Paint
$38.48
item(s): 41618
POR-15 Detail Paint
Replicate the original look of metals on cast parts with POR-15 Detail Paint
POR-15 Detail Paint provides a professional grade finish that reproduces the original look of cast parts. POR-15 Detail Paint is designed to have a low sheen. This steel color paint will not yellow and will keep your restored component looking factory new. POR-15 Detail Paint is formulated to provide maximum corrosion resistance and protect metal substrates against weather, sunlight, oil and water. Check out this metal looking paint today!
Applications: master cylinder, steering box, transmission housings, hood springs, driveshaft, suspension components etc.
- Detail Paint Technical Data Sheet
Aluminum: WARNING: This product can expose you to chemicals including ethyl benzene, which is known to the State of California to cause cancer, and Toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Cast Iron Grey: WARNING: This product can expose you to chemicals including ethyl benzene and carbon black, which are known to the State of California to cause cancer, and Toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Stainless Steel: WARNING: This product can expose you to chemicals including ethyl benzene, which is known to the State of California to cause cancer, and Toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Metal that is rough media blasted provides the best surface for coatings. If not possible, remove all built-up dirt, loose rust, and paint. Note that if you leave old paint behind, the new coating can only adhere as strongly as the paint it is applied over. This generally is not as strong as applying to prepped and scuffed-up bare metal. For new metal or smooth surfaces, roughen with 220-320 grit pad/paper. For the best protection against corrosion, we recommend applying the POR-15 Rust Preventive Coating as a primer on bare metal, after the surface has been cleaned and prepped.
These products should only be handled when wearing latex gloves, eye protection, and a proper respirator. Always work in a well-ventilated area.
Step 1. Apply our POR-15 Cleaner Degreaser to a surface, keep wet 10-15 minutes and agitate the surface with a scuff pad or stiff brush to brake up oil and grease. Then rinse thoroughly with water and allow the surface to dry. Repeat if surface is still oily or greasy. It is important not to allow the product to dry on the surface while working or prior to rinsing with water. POR-15 Cleaner Degreaser is a heavy duty water soluble cleaner that may be used over metal, wood, fiberglass, vinyl and concrete.
Step 2. Apply POR-15 Metal Prep to the bare metal surface, keep wet 10-30 minutes then rinse thoroughly with water and allow the surface to dry. It is important not to allow POR-15 Metal Prep to dry on the surface prior to rinsing with water. Once dry the surface may show a flash rust or white powdery residue this is perfectly normal. POR-15 Metal Prep provides the best surface profile and greatly improves paint adhesion to any type of metal surface for opaque paints and coatings.
Step 3. Shake can at least one minute before applying and occasionally during use. Apply in two to three light coats. Several light coats give a better finish than one heavy coat. Spray 8-12 inches from the surface. Spray first coat in a top to bottom motion and the second coat in a right to left motion. Allow each coat to dry before applying another. For best results, recoat within 1 to 24 hours.
Cleanup: To prevent clogs in spray nozzle, hold can upside down and spray until clear gas appears.